Engineered hydronic PEX, electric mats, polished concrete slabs, and retrofit radiant — designed to heat-loss models, installed by P1 master plumbers, and tied into 95%+ AFUE condensing boilers for custom homes across the GTA.
Tell us your project — a senior radiant specialist calls back inside 30 minutes with next steps.
Radiant doesn't blow air, doesn't dry out the home, and doesn't leave cold pockets along exterior walls. Heat is delivered at the floor — where occupants live — and pairs with high-efficiency condensing boilers to lower supply temperatures, reduce stratification losses, and cut runtime on the coldest GTA winter nights.
Typical supply temperature on our designs: 85–120°F — condensing-friendly.
From a 5,000 sq ft Kleinburg estate to a Toronto retrofit en-suite, every Perruzza radiant system is sized to the heat-loss model and detailed to the architectural finish.
Engineered radiant loops for 2,500–12,000 sq ft custom homes across Vaughan and the GTA — designed to heat-loss calculations, not generic templates.
Slab-embedded PEX loops poured into structural and topping slabs for basements, sunrooms, and contemporary main floors with polished concrete finish.
Joist-bay aluminum heat-transfer plates installed from below — adds radiant heating to existing custom homes without tearing up finished floors.
Glycol-loop hydronic snowmelt cast under interlock, concrete, and stone driveways — eliminates plowing, salt, and slip risk for estate properties.
Full mechanical-room redesign with 95%+ AFUE condensing boilers, manifolds, mixing valves, and outdoor reset — sized for radiant, snowmelt, and DHW.
From the first walk-through to the final boiler tune-up, every Perruzza radiant project is delivered by fully licensed Mechanical Contractors — assessed, installed to code, and maintained for the long run.
As fully licensed Mechanical Contractors, we walk the home, review architectural drawings, and run a room-by-room heat-loss assessment so the system is sized to your build — not a generic template.
Every loop, manifold, and boiler is installed to Ontario Building Code, TSSA, and CSA B214 standards by our licensed Mechanical Contractors — pressure-tested, documented, and inspection-ready.
After commissioning, our licensed Mechanical Contractors return for seasonal tune-ups, glycol checks, and boiler service so your radiant system runs efficiently for decades, not just the first winter.
These are the design parameters we hit on a typical Vaughan or GTA custom home install — calibrated to the home's heat-loss, finish materials, and the condensing boiler plant driving the system.
Discuss My ProjectBuilders, architects, and homeowners across the GTA pick Perruzza for radiant work because we don't cut corners on licensing, design engineering, or the craftsmanship a custom hydronic system requires.
Call 647-919-9619From Kleinburg estates and Woodbridge custom builds to Toronto retrofits and Mississauga new builds — Perruzza designs and installs radiant systems across the entire GTA.
2026 pricing, GTA permits, and energy efficiency — the three questions Vaughan and GTA homeowners ask us most often before committing to a radiant floor heating system.
Send us your project — square footage, finishes, timeline — and a senior radiant specialist will call back inside 30 minutes with next steps for a Vaughan or GTA design-build.
Tell us your address and project scope — we'll line up the right senior specialist for a Vaughan or GTA radiant consult.
